BoosterPlug is accepted worldwide as a very effective fuel injection
tuning method for your BMW S1000R S1000XR S1000RR motorcycle. It will
transform your motorcycle at low rpm from OK to Excellent.
It is not necessary to spend a lot of money on a Power Commander + dyno-tuning to make your bike run properly.
BoosterPlug works alongside the fuel injection ECU to make the air /
fuel mixture slightly richer. This is the best way to eliminate typical
fuel injection problems:
unpredictable throttle response,
poor idle and poor running at low speed.
BoosterPlug can be installed in 10 minutes. It plugs directly into your
motorcycle wiring loom, using its original connector. You do not need
to cut any cables, there is no computer programming, there are no
BoosterPlug recommends that you do not remove the O2
sensor in any situation. When you remove the O2 sensor, the ECU will see
the air / fuel ratio as being too lean but often the software does not
allow the fuel mixture to be as rich as is necessary. In addition the
ECU will only make the change in mixture if it trusts the O2 sensor
signal. And this is normally when you are riding the bike at a steady
speed on the open road. This means that you will get the richer mixture
where you need it the least. So you waste fuel at higher speeds and run
the risk of it still being too lean at low speeds.